Help! How to make a instance to an image successfully?

	Corporate Home Open Source Home	Download Eucalyptus \| Contact Us \| Blog
	Learn What is Eucalyptus Cloud IT Roles Case Study: ECC Issue tracker Test Drive Community Cloud FastStart Download Read FAQs Presentations Security Information Guides... Administrator's Guide User's Guide Tools Participate Community Wiki Roadmaps Developers Forum Announcements Articles & Blogs Community Cloud General Discussion Site Feedback Support Questions Bug Tracker Planet Eucalyptus Blog Contact

1 reply [Last post]

Mon, 02/08/2010 - 04:25

quanwei

Offline

Joined: 02/08/2010

Hi,everyone:
I am a new learner of Euclyptus systems. Now I met an mind-bending problem。Thus,I have tried make an image to produce an instance.The image is from the official network，I download it from http://open.eucalyptus.com/。
My eucalyptus cloud version is 1.5.2。 Happily， the instance running successfully,and I have installed many software in the instance . Unfortunately，I cannot make the instance into image successfully. In detial,the "image" which I made cannot re-run again in the eucalyptus cloud.

I want to know what is the STEPS I should do ,when I make a instance to a successful image .

Thanks a lot! :)

Mon, 02/08/2010 - 16:53

graziano

Offline

Joined: 01/14/2010

Hello, I'm not fully sure if

Hello,

I'm not fully sure if I understand your question: are you asking how to customize an image? If so, look into the community wiki: there are some document which may help you. You could also use euca-bundle-vol to bundle a running image.

cheers
graziano